Overview
Neurons carry messages very fast using a combination of electrical signals along the cell and chemical signals between cells. This unit follows the four video lessons: neuron structure and the resting potential, action potentials and how they travel, synapses and neurotransmitters, and how a neuron adds up excitatory and inhibitory inputs.
Electrical signals travel along a neuron as action potentials. Between neurons the message is chemical: a neurotransmitter crosses the synapse.
Lesson 1: Neuron Structure and the Resting Potential
Structure of a neuron
- Dendrites receive signals.
- The cell body contains the nucleus and most organelles.
- The axon carries the signal away; many axons are wrapped in a myelin sheath with gaps called nodes of Ranvier.
- Axon terminals release neurotransmitter.
Sensory neurons carry impulses toward the central nervous system, relay neurons connect neurons inside it, and motor neurons carry impulses to muscles and glands.
The resting potential
A neuron that is not sending a signal has a resting membrane potential of about -70 mV: the inside is negative compared with the outside. Three things create it:
- The sodium-potassium pump uses ATP to move 3 Na+ out and 2 K+ in.
- The membrane is much more permeable to K+ (through leak channels) than to Na+, so K+ leaks out and leaves the inside more negative.
- Large negatively charged molecules stay inside the cell.
For a resting-potential question, always mention the pump (3 out, 2 in, uses ATP) and the leaking potassium channels. The pump alone is not the full explanation.
Lesson 2: Action Potentials and Nerve Impulse Propagation
An action potential is a brief reversal of the membrane potential that travels along the axon. It has these stages:
- Stimulus raises the potential to the threshold (about -55 mV).
- Depolarisation: voltage-gated sodium channels open, Na+ rushes in, and the inside becomes positive.
- Repolarisation: sodium channels close and voltage-gated potassium channels open. K+ flows out and the inside becomes negative again.
- Hyperpolarisation and recovery: the potential briefly dips below resting level, then the pump and leak channels restore -70 mV. During this time the neuron cannot fire (the refractory period), which makes the impulse travel one way.
Action potentials are all-or-nothing: if the threshold is reached the full action potential fires, and a stronger stimulus does not make it bigger. Stronger stimuli produce more frequent impulses.
Propagation
Ions flowing in at one point spread to the next section of the axon, bringing it to threshold. In myelinated axons the impulse jumps from one node of Ranvier to the next, called saltatory conduction, which is much faster. Speed also increases with a larger axon diameter.
Sodium does not "flow out" during depolarisation. Na+ flows in during depolarisation and K+ flows out during repolarisation.
Lesson 3: Synapses and Neurotransmitter Release
A synapse is the junction between a neuron and another cell, with a tiny gap called the synaptic cleft. Transmission at a chemical synapse follows a fixed order:
- An action potential reaches the presynaptic terminal.
- Voltage-gated calcium channels open and Ca2+ enters.
- Calcium causes vesicles of neurotransmitter to fuse with the membrane and release their contents by exocytosis.
- The neurotransmitter diffuses across the cleft.
- It binds to receptors, often ligand-gated ion channels, on the postsynaptic membrane, opening them.
- The neurotransmitter is removed: broken down by an enzyme (for example acetylcholinesterase breaks down acetylcholine) or taken back up into the presynaptic neuron.
Because only the presynaptic side releases neurotransmitter and only the postsynaptic side has the receptors, transmission is one-way. Crossing the cleft causes a small synaptic delay.
Removing the neurotransmitter is as important as releasing it. Without removal, the postsynaptic cell would be stimulated continuously.
Lesson 4: Excitation, Inhibition, and Summation
Neurotransmitters do not always make the next neuron more likely to fire.
- Excitatory neurotransmitters (for example glutamate) open channels that let positive ions in and make the postsynaptic membrane depolarise a little, moving it toward threshold. This small change is an excitatory postsynaptic potential.
- Inhibitory neurotransmitters (for example GABA) open channels that let negative ions such as Cl- in, or K+ out, and make the membrane hyperpolarise, moving it away from threshold.
Summation
A single synapse rarely causes an action potential. The neuron adds up all its inputs, mostly at the start of the axon:
- Spatial summation: inputs from several different synapses at the same time.
- Temporal summation: repeated inputs from the same synapse in quick succession.
If the combined effect reaches the threshold, an action potential fires. If excitatory and inhibitory inputs cancel out, it does not.
Use the terms threshold, depolarise and hyperpolarise precisely. An inhibitory input makes the potential more negative, further from threshold.
Exam Application
- Paper 1: read a graph of an action potential and say which ions are moving at each stage, or identify the correct order of events at a synapse.
- Paper 2: Explain how the resting potential is maintained, describe the events of an action potential, outline synaptic transmission, or compare myelinated and unmyelinated axons.
- Link every ion movement to a named channel or pump: voltage-gated Na+ channels, voltage-gated K+ channels, Na+/K+ pump, voltage-gated Ca2+ channels.
Misconception Breakdown
- "A bigger stimulus gives a bigger action potential." No. Action potentials are all-or-nothing; a bigger stimulus means a higher frequency.
- "The nerve impulse is electrons flowing along the axon like a wire." It is a wave of changing membrane potential caused by ions moving through channels.
- "Neurotransmitters pass through the postsynaptic cell." They bind receptors on its surface and are then removed.
Quick Revision
- Resting potential: about -70 mV; Na+/K+ pump (3 Na+ out, 2 K+ in) plus K+ leak channels.
- Action potential: threshold, then voltage-gated Na+ in (depolarise), then K+ out (repolarise), then hyperpolarise and refractory period.
- All-or-nothing; stronger stimulus means higher frequency. Myelin means saltatory conduction and faster impulses.
- Synapse: Ca2+ in, vesicles release neurotransmitter by exocytosis, it diffuses, binds receptors, then is removed (enzymes or reuptake).
- Excitatory depolarises; inhibitory hyperpolarises. Summation (spatial and temporal) decides whether threshold is reached.